Tree removal can be quite dangerous and also life-threatening. It is never recommended to remove a tree all on your own unless it is a small one that you are confident it is possible to handle safely. Otherwise, tree removal should be left in the hands of professionally-trained and equipped tree service contractors. If you have a tree on your own property that's fairly small, but needs to be removed, it is possible to possible do-it-yourself with the proper tools, knowledge, and planning.
Tree Removal Preparation
Proper preparation for small tree removal involves gathering all of your needed supplies, along with, a thorough inspection of the tree. Look to see if the tree leans one way or the other, and plan a getaway route in case it generally does not fall the way you expect it to fall. Also, examine whether there are any obstacles in any direction of the tree, including vehicles, structures, and other trees. For anyone who is sure there's enough safe clearance for the tree to fall, then you can move ahead to gathering your equipment and tools. This consists of:
Safety Gear (Utility gloves, goggles, hard hat, steel toe boots, etc.)
Chainsaw
Ax or Hacksaw
Ladder
Rope
Wedges
First Aid Kit
To Remove a Tree
Once you have all of your equipment and supplies, you can aquire started removing the tree. First, use your ax to knock on the bark a few times, and in several different places, to learn how solid or hollow the tree is. Getting a less dense area to cut will undoubtedly be easier. Next, plan which side of the tree you need to make your cut. Look to see where the tree naturally leans; it is best to cut a tree in the direction in which it really wants to naturally fall. Be sure the area where the tree drops is level so the tree does not roll or bounce after it falls.
Make a horizontal cut at hip-height, and about 1/3rd into the tree. Do this on the side of the tree where you need it to fall. If you need the tree to fall to the proper, you must cause you to cut on a single side so that it falls inward, towards the cut. The tree will fall perpendicular to your horizontal cut. Your second cut should create a wedge into the tree. So make the second cut at an angle from the initial cut. It should look like a lemon wedge.
Your third cut is called a back cut, and is ought to be made on the contrary side of one's wedge cut. This cut can make the tree fall over privately of your wedge cut. Ensure it is about 1.5 inches above the wedge cut, and as thick as possible. Also you can use a wedge to prevent the tree from settling onto the chainsaw. Add more wedges as necessary before tree begins to fall. Then run! But usually do not turn Website link on the tree as it falls.